ConnectGear WA300 - Manual (Page 25)

11Mbps Wireless Access Point User's Manual
The IP Addr Tab
IP ADDR: displays the status of current IP setting .
IP Address Mode: Select “Static” or “DHCP” mode. For “Static” mode, the IP
address settings are given by user. For “DHCP” mode, these
settings will be overridden by a DHCP server on your network.
The default setting is “Static”
IP Address: The static IP address you want to assign to the AP. The default value
is “192.168.1.100”.
IP Subnet: The subnet mask you want to assign for the AP. The default value is
“255.255.255.0”.
IP Gateway: The gateway you want to assign for the AP. The default value is
“192.168.1.1”.
Allow upgrade uploads: Check the box, and then it is allowed to upgrade
firmware.
Note! You may need to re-load the page to see any new settings.
25