DFI SB332-C - Manual (Page 34)

www.dfi .com
34
Chapter 3 BIOS Setup
Chapter 3
Parellel Port Configuration
Change Settings
Selects the IO/IRQ setting of the I/O device.
Device Mode
Change the printer port mode.
Enable or Disable Parellel
Port (LPT/LPTE)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Parellel Port Confi guration
Parellel Port
Device Settings
Change Settings
Device Mode
Advanced
[Enabled]
IO=378h; IRQ=7;
[Auto]
[STD Printer Mode]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Second Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Set parameters of Serial
Port 3(COMC).
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Second Super IO Confi guration
Super IO Chip
 Serial Port 3 Confi guration
 Serial Port 4 Confi guration
 Serial Port 5 Confi guration
 Serial Port 6 Confi guration
Advanced
Fintek F81217
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 3 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=3F8h; IRQ=5;
[Auto]
Serial Port 3 Configuration to Serial Port 6 Configuration
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit