Diamondback Fitness 910Ic - Manual (Page 10)

10
910Ic ASSEMBLY INSTRUCTIONS
• Unpack the 910Ic from the carton. Please recycle.
• Verify the carton contains all parts from the list.
• Remove the blocking (the short section of tubing
installed at the factory to prevent damage to the
front frame during shipping) by removing the two
fixing screws shown in Figure 1 above. Discard this
piece.
• Align the front stabilizer (D) with the receiver located in the
front of the frame, and loosely install four (4) H-1 bolts, two
(2) curved washers (H-2) and two (2) flat washers (H-3),
making sure that the correct shape of washers are installed on
their corresponding surface profile; i.e. flat washer on the flat
surface, etc. When all bolts have been inserted, tighten for
final installation.
• Repeat this process for the rear stabilizer assembly (E).