Digi-Star EZ400 - Manual (Page 16)

Weighing Errors
12 EZ400 User’s Manual D3655-US Rev E
WEIGHING ERRORS
Over-Capacity Limit (
OVRCAP
)
The display shows the message "OVRCAP" if the weight on the scale system
exceeds the capacity limit. The capacity value is entered in SETUP to warn of
overloading the scale system.
Over Range (
+RANGE
)
The display shows the message "
+RANGE
" if the weight on the scale system
exceeds the maximum weight measurable by the scale system. The over
range value is always the system’s maximum A/D counts multiplied by the
scaling factor. The actual weight at which over range occurs depends on the
calibration, zero, and display count size.
Under Range (
-RANGE
)
The display shows the message "
-RANGE
" if the weight on the scale system is
less than the minimum weight measurable by the scale system. The under
range value is always the system’s minimum A/D counts multiplied by the
scaling factor. The actual weight at which under range occurs will depend on
the; calibration, zero, and display count size.
Low Battery Indication (
LO BAT
)
If the supply voltage drops below the (10.5 Volts), the message
“ RECHARGE
BATTERY - TURNING OFF ”
and
“ LO BAT ”
will periodically show on the display to alert
the operator of the low battery condition.
RUN SELF TEST
1. Press then during
normal system operation to start
self-test.
1