DR Power Walk-behind Pro - Manual (Page 16)

16 DR ®
FIELD and BRUSH MOWER
1. Slide one end of the Clear Plastic Tube over the Oil Drain Connector (Figure
10 Kawasaki, Figure 11 Briggs) and the other end into the Oil Drain
Container.
2. For Kawasaki Engines, open the Drain Connector with a 10mm Wrench or
Flat Head Screwdriver to drain the Oil (Figure 10).
3. For Briggs Engines, pull the Cap off the Oil Drain Connector, push in and
rotate the Drain Connector to the left to drain the Oil (Figure 11).
4. Remove and replace the Oil Filter as described in the Engine Operator
Manual.
5. Close the Oil Drain Connectors and replace the Oil as described in the
Engine Operator Manual.
LUBRICATING YOUR MACHINE
Your DR FIELD and BRUSH MOWER was greased at the Factory. The operator
needs to periodically lubricate the Wheel Clutch Cable, Brake Cable, Belt Idler
Arm, Drive Chain, and the Differential Lock In/Out Cable and Sleeve Shaft.
Tools & Supplies Needed:
•
Grease Gun w/General Purpose Grease
• 1/2" Wrench or Socket (Chain Cover)
•
SAE 30 oil
Lubricate the Parking Brake Cable, Wheel Drive Clutch Cable, and the
Differential Lock In/Out Cable with SAE 30 oil. Apply the lubricant into the
Cable Housing while working the Cable back and forth a few times. Do this at
both ends of the Cables (Figure 12). Perform this lubrication more often in dry
and dusty environments.
Lubricate
Right Side Left Side
Lubricate
Lock In/Out Cable
Clutch
Cable
Underneath Machine Figure 12
Clear Plastic
Tube
Figure 10
Oil Drain
Connector
Open
Clear Plastic
Tube
Figure 11
Oil Drain
Connector