DR Power Premier 6.5fpt Kohler - Manual (Page 17)

CONTACT US AT www.DRpower.com 17
Always make sure you remove the screwdriver from the head assembly when
finished. Failure to remove the screwdriver could cause injury when the head
assembly is engaged.
CUTTING HEAD REASSEMBLY
1. Place the Spacer and Anti Wrap Canister (with the lip facing up) onto the
Shaft (Figure 18).
2. Align the flats at the center of the Plates with the flat on the shaft and slide
the Line Plates onto the Shaft. Ensure they are facing top side up as shown.
3. Place the head of the Mow-Ball ® Bolt so it is sitting in the hex cavity at the
bottom of the Mow-Ball ® .
4. Looking down at the top of the Frame, hold the Bolt Head in place with your
finger and turn the Mow-Ball ® counterclockwise to start the Bolt into the
Shaft.
5. Insert the Screwdriver as shown in Figure 17 on page 14 and tighten the
assembly securely by turning the Mow-Ball ® counterclockwise when looking
down on the top of the Frame.
NOTE: When finished there should be no gaps between any of the components.
Figure 18
Spacer
Line Plates
Anti Wrap
Canister
Mow-Ball ®
Mow-Ball ®
Bolt
Improper installation can cause damage to the trimmer bearings. Follow
these directions carefully to protect your machine from damage. Reassemble
the components in the order shown in figure 18.