DR Power Premier 6.5fpt Kohler - Manual (Page 19)

CONTACT US AT www.DRpower.com 19
Replacing the Wheels
Tool needed:
 5/8" Wrench
1. Block and stabilize the machine so that the Wheels are off the ground.
2. Loosen and remove the Locknut (Figure 22).
3. Slide the Wheel off the Axle.
4. Reverse the steps to install the new Wheel.
Changing The Engine Oil
Tools and Supplies needed:

SAE 30 HD Oil (refer to your Engine Owner’s Manual for quantity required)

Suitable container for used oil
 Rags
 Wooden pallet or workbench
NOTE: Drain the oil when the Engine is warm. Warm oil drains quickly and
completely.
1. For convenience, place the machine up on a wooden pallet or workbench.
2. Remove the Oil Cap/Dipstick and position a suitable oil receptacle beside
the Oil Fill Tube.
Note: The Subaru Pro-XL engine has an oil drain fitting you can use instead of the
oil filler tube.
3. Make sure to securely tighten the Gas Fill Cap.
4. Using the handle of the DR TRIMMER/MOWER, tip the machine to drain
the oil out through the Oil Filler Tube into a suitable receptacle (Figure 23).
5. Refill the Engine using SAE 30 HD oil to the level indicated on the Dipstick.
NOTE: Be sure to use environmentally safe disposal procedures in the disposing of
the used oil.
Approved
Container
Figure 23
Oil Cap/Dipstick
Fuel Fill Cap
Locknut
Figure 22
Wheel