DR Power Dual Action 15-Ton Gas (Aug 2011 - Present) - Manual (Page 11)

CONTACT US AT www.DRpower.com 11
Note: The Slots of the Engine Mount are for Gas Engine mounting and the round
holes are for Electric Motor mounting.
16. Position the Engine onto the Bracket and align the Engine Base holes with
the slots of the Bracket (Figure 11).
17. Electric Start only: Route the Harness down to the front left corner of the
Engine and connect the green wire ground Terminal of the Harness to the
Engine mounting flange with a Bolt, Flat Washers (top and bottom) and
Locknut using two 1/2" Wrenches (Figure 12).
18. Install the four sets of Bolts, Flat Washers (top and bottom) and Locknuts
using two 1/2" Wrenches to secure the Engine to the Mount (remaining
three sets for electric start).
Note: Remove protective Caps as needed for the following Hydraulic Hose
connections.
19. Install the Elbow Hydraulic Fitting into the Tank assembly by hand until it
cannot be turned any more with your hand. If needed, turn the Elbow back
to align it parallel with the ground and facing out (Figure 13).
20. Tighten the Elbow Jam Nut against the Tank with a 7/8" Wrench.
21. Use Wire Cutters to cut the Cable Ties holding the Hydraulic Hoses
together.
22. Install the Fluid Suction Hose onto the Pump and Tank fittings using a 7/8"
Wrench.4
23. Slide the Sheathing over one of the Pressure Hoses and secure it to the
Hose with a Cable Tie near each end (Figure 14).
Note: When installing the following Hose fittings they should be tight, but try not
to over tighten. Start with a snug fit and if leaking is detected then tighten a
bit more until no leaks are detected.
24. Install the Hose with Sheathing to the Control Valve (long elbow end) and
Pump using a 7/8" Wrench.
25. Install the Fluid Return Hose (long elbow end) at the Control Valve and the
top of the Tank using a 7/8" Wrench (Figure 15).
Engine
Hardware
Figure 11
Engine
Mount
Wire
Harness
Figure 12
Hole
Ground
Terminal
Suction
Hose
Figure 13
Elbow
Jam Nut
Pump
Pressure
Hose
Figure 14
Sheathing
Long Elbow
Pump
Control
Valve
Cable Tie
Cable Tie
Fluid Return
Hose
Figure 15
Long Elbow
Tank