DR Power Hydraulic 5-Ton (Oct 2010 - July 2013) - Manual (Page 24)

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
©2010 Country Home Products, Inc. All rights reserved 289291
Daily Checklist for the DR 5-TON WOOD SPLITTER
To help maintain your DR 5-TON WOOD SPLITTER for optimum performance, we recommend you follow this checklist each
time you use your Wood Splitter.
[ ] Clean the log Ram and Guides.
[ ] Check the Splitting Wedge for damage and sharpness.
[ ] Check the general condition of the Wood Splitter, e.g.; nuts, bolts, welds, etc.
[ ] Check the Ram for smooth travel.
[ ] Check the condition of the electrical cord.
[ ] Check the hydraulic fluid level
End of Season and Storage

Wipe down the DR 5-TON WOOD SPLITTER to remove any moisture, wood chips, and dirt that may have accumulated on
the Log Guides and Operating Handle..
 Apply a thin coating of oil or #2 Lithium Grease to the leading edge of the Splitting Wedge.
 Relieve any internal air pressure by turning the Air Bleed Screw counter-clockwise 4 times to open, and then retighten by
turning clockwise prior to storing the machine (Figure 7 on page 10). DO NOT OVER TIGHTEN!

If possible, store the Wood Splitter in a dry, protected place. If it is necessary to store the Wood Splitter outside, cover it
with a protective material (especially the Motor).
NOTE: A Protective Cover, Item Number 21020, is available through DR Power Equipment. Visit our website at
www.DRpower.com or call Toll-Free 1-800-DR-OWNER (376-9637).
Before performing any repairs or maintenance procedure, unplug the Wood Splitter power cord from the power source.
Before performing any repairs or maintenance procedure, unplug the Wood Splitter power cord from the power source.