DR Power Hydraulic 5-Ton (Oct 2010 - July 2013) - Manual (Page 9)

CONTACT US AT www.DRpower.com 9
Assembling the DR 5-Ton Wood Splitter
Tools Needed:

10mm Wrench
1. Install the Rolling Wheel Bracket onto the rear of the Splitter with two Bolts,
Lock Washers and Flat Washers at the rear and two Bolts, Lock Washers and
Flat Washers on each side using a 10mm Wrench (Figure 3).
Note: Ensure that you install the Tabs of the Rolling Wheel Bracket under the Side
Rails.
2. Slide the Rubber Grip onto the Front Handle Shaft and screw the Handle
Brackets onto the Front handle Shaft until snug. Align the Brackets parallel
to each other (Figure 4).
3. Install the Front Handle to the Splitter with two Bolts, Lock Washers and Flat
Washers on each side (4 total) using a 10mm Wrench (Figure 5).
4. Roll the Splitter over onto the Legs and Wheels.
5. Install the Control Lever Guard to the Splitter with two Bolts, Lock Washers
and Flat Washers using a 10mm Wrench (Figure 6).
6. Screw the Control Lever Grip onto the Control Lever Shaft.
Wheel
Assembly
Figure 3
Bolt, Lock Washer
and Flat Washer
Front
Handle
Brackets
Figure 4
Front Handle
Shaft
Front Handle
Grip
Front
Handle
Assembly
Figure 5
Bolt, Lock Washer
and Flat Washer
Control
Lever
Guard
Figure 6
Control
Lever Grip
Bolt, Lock
Washer and
Flat
Washer
For your own safety, do not connect the log splitter to the power source until
the machine is completely assembled and you read and understand the entire
instruction manual