DR Power TPH-184CHP - Manual (Page 10)

SECTION II - ASSEMBLY & INSTALLATION
PACKAGE CONTENTS
SKID POLY BAG BOLT BAG PART # WHERE USED
SHREDDER/CHIPPER OWNER’S MANUAL 1 EA – ¼” X ¼” X 1 ½” KEY 080-0080 PTO SHAFT
CHIPPER HOPPER WARRANTY CARD 4 EA – 5/16-18 X ¾” CARRIAGE BOLT 090-0462 CHIPPER HOPPER
SHREDDER HOPPER SAFETY GLASSES 4 EA – 5/16 FLAT WASHERS 090-0233 CHIPPER HOPPER
P.T.O. DRIVE SHAFT BOLT BAG 8 EA – 5/16-18 NYLOCK NUT 090-0460 4 EA – CHIPPER HOPPER
4 EA – SHREDDER HOPPER
POLYBAG 2 EA – 3/8-16 X 3/8” SET SCREWS 080-0056 PTO SHAFT
2 EA – 5/16-18 X 1 ¼” HHCS 090-0089 SHREDDER HOPPER
2 EA – 5/16-18 X 1 ½” HHCS 090-0090 SHREDDER HOPPER
4 EA – ANTI-VIBRATION MOUNTS 500-0068 SHREDDER HOPPER
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
• ½” Wrench or socket
ASSEMBLY
STEP I – UNPACKING AND CHECKING CONTENTS
• Remove the all items from the crate.
• After unpacking the crate, compare the contents with the list above.
• If any parts are missing, contact your place of purchase.
• Assembly should be done on a clean, level surface.
STEP II – ASSEMBLING THE CHIPPER HOPPER
• Assemble chipper hopper to the basic machine using four each 5/16”-18 x ¾” carriage bolts, 5/16”-18 nylock nuts
and 5/16” flatwashers from the bolt bag. Put head of bolt inside hopper with threads sticking out. Tighten all
hardware with a ½” wrench.
10