DR Power Lawn Mower Subaru Engine (January 2013 - March 2014) - Manual (Page 10)

10 DR ® SP22 MOWER
1. Place the machine on a level surface remove the Dipstick (Figure 7).
2. Machines are shipped with no oil. Initially add 16 oz. of the oil
recommended by the Engine Manufacturer. Wait one minute for the oil to
settle.
3. Replace the Dipstick, but DO NOT screw it in, to ensure an accurate reading
and then remove it to check the oil level (clean the Dipstick with the rag after
checking).
4. Continue adding a few ounces of oil at a time, rechecking the Dipstick until
the oil reaches the fill mark. Be careful not to overfill.
5. Replace the Dipstick and screw all the way down when full.
6. Remove the Gas Fill Cap and fill the Gas Tank with fresh, unleaded gas (with a minimum of 85 Octane) to approximately 1" to
1-1/2" below the top of the fill neck to allow for fuel expansion (Figure 7). Be careful not to overfill and reinstall the Gas Fill
Cap before starting the engine. See your Engine Owner’s Manual for more detailed information.
NOTE: To refill the gas tank, turn the engine OFF and let the engine cool at least five minutes before removing the gas fill cap.
Figure 7
Fuel Fill
Oil Fill
Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others.

To prevent a static from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a
vehicle or on an object.

Fill the tank outdoors when the engine is cold. Wipe up spills.

Do not handle gasoline when smoking or around an open flame or sparks.
 Store gasoline in an approved fuel container, out of the reach of children.