DR Power Backhoe 2008 - Manual (Page 29)

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 25
Hitch
Pin
Figure 24
Hitch
Pin
Hitch Pin
Storage
4. Raise the Front Stabilizers to the Vertical position
(Figure 22).
5. Line up the holes in the Front Stabilizers and insert
the Hitch Pins. Secure the Hitch Pins with the Lynch
Pins.
6. Start the Backhoe Engine and raise the Boom to lower
the Backhoe onto the Wheels (Figure 23).
7. Use the Controls to center and pull in the Boom, pull
the Crowd arm all the way towards you, and pull the
Bucket in. This will line up the holes for the next step.
NOTE: You may need to check that the holes are aligned
properly before you shut down the Engine.
8. Move the Throttle Control Lever to the idle position
and turn the Engine Ignition Switch to “OFF”.
9. Remove the Lynch Pins from the Hitch Pins and then
remove the two Hitch Pins from the storage area.
Install the Hitch Pins into their positions to lock the
Boom in place (Figure 24).
Figure 22
Front
Stabilizer
Lynch
Pin
Hitch
Pin
Figure 23