Towing the backhoe – DR Power Backhoe 2008 User Manual
Page 31
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 27
13. Remove the Hitch Pins of the Rear Stabilizers and
rotate them into their upright position until the
holes are aligned (Figure 28).
14. Reinstall Hitch Pins into the Rear Stabilizers and
secure with the Lynch Pins.
Towing the Backhoe
The Backhoe must be prepared for towing by following the
procedures in the previous “Preparing the Backhoe for
Towing” section first.
1. Position the Backhoe behind the tow vehicle and raise
or lower the Jack to position the Tow Hitch just over
the Tow Ball (Figure 29).
2. Pull the Latch Assembly of the Tow Hitch Assembly up
and into the open position.
3. Lower the Hitch Coupler of the Backhoe onto the tow
vehicle’s Tow Ball (must be a 2" tow ball) by lowering
the Jack until all the weight is on the Tow Ball and the
Jack Base comes off the ground (Figure 30).
Hitch
Pin
Figure 28
Lynch Pin
Rear
Stabilizers
Figure 29
Tow
Hitch
Assembly
2" Tow Ball
Latch
Assembly
Figure 30
Tow Hitch
Assembly
Jack
Base
Tow Ball
Jack Handle