DR Power Redi-Plow Plus (Sept. 2013 - Present) - Manual (Page 9)

CONTACT US AT www.DRpower.com 9
16. At tongue and groove joint, drill a 5/16" pilot hole at factory mark in v-
groove at each end of blade (Figure 16).
17. Using a 9/16" wrench, turn a (short) 3/8" self threading bolt into 5/16" pilot
hole and tighten (Figure 17). Repeat at other end.
18. Using torque wrench, tighten all (6) bolts on each slide hinge to 31 ft/lbs.
(Figure 18).
19. At bottom of blade, check to make sure rubber edge is centered, then drill a
3/16" pilot hole at factory mark in v-groove (4 locations) – drill only through
first layer of aluminum and into rubber (Figure 19). Repeat this drilling
procedure for three remaining marks.
20. Using Phillips #3 bit, run a self drilling screw into each of the four pilot holes
(Figure 20). This prevents rubber from movement.
21. Hang blade on push frame in the transport position and insert key hole pins
(Figure 21).
22. Attach tether cord to pins by feeding end of cord through hole in pin and
tying a square knot (Figure 22).
Figure 17
3/8" Self
Threading Bolt
Drill 5/16" Hole at
Factory Mark (1 at
each end)
Figure 16
*Torque Bolts to 31 ft/lb.
Figure 18
#3 Philips
Self Drilling
Screw
Figure 20
Keyhole Pin
Figure 21
Slide Hinge
Tether
Cord
Square
Knot
Figure 22
3/16" Drill Bit
Figure 19
Factory
Mark
(4X)