DR Power TreeChopper - Manual (Page 14)

14 DR ®
TreeChopper™
Note: The Cross Bar can be angled front to back as needed to align with the hole in
the Universal Mount as long as it rests flat against the ATV Frame Tube.
12. Tighten the U-Bolt or Bolt Hardware with a 9/16" Wrench(es).
13. Tighten the Bolt and Locknut going through the Cross Bar tabs with two
9/16" Wrenches.
14. Install the Tree Cutter Chassis to the Universal Mount with the two Pivot
Pins (head facing out) and Hairpins (pushed all the way on as shown)
(Figure 14).
15. Attach the extension arms to the Chassis with a 1/4-20 X 2-1/4" Bolt, two
1/4" Washers and a 1/4-20 Locknut for each arm (Figure 15). Tighten with
two 7/16" Wrenches.
16. Attach the Tree Guard to Chassis with four 3/8-16 X 1-1/2" bolts, eight
Fender Washers (one on the Bolt side and one on the Locknut side) and four
3/8-16 Locknuts using two 9/16" Wrenches (Figure 16).
Extension Arms
Figure 15
Bolt,
Flat Washers
and Locknut
Arm Bend
Facing Back
Chassis
Figure 14
Pivot Pins
Hairpin
Tree Guard
Figure 16
Bolt, Large Flat
Washers and Locknut
Lifting Device
The U-Bolt or Bolt Hardware must be tight to ensure that there is a strong
connection between the Mounts and Frame, but do not over-tighten. Over-
tightening could cause damage to your ATV frame and could weaken the
Hardware attaching the TreeChopper Frame to your ATV.