Product identification, Safety information – Desa VYM27NR User Manual

Page 4

Advertising
background image

www.desatech.com

108382-01G

4

SAFETY INFORMATION

Continued

1. This appliance is only for use with the type of

gas indicated on the rating plate. This appliance

is not convertible for use with other gases.

2. Do not place propane/LP supply tank(s) in-

side any structure. Locate propane/LP supply

tank(s) outdoors (propane/LP units only).

3. To prevent performance problems, the use

of a propane/LP tank of less than 100 lbs.

capacity is not recommended (propane/LP

units only).

4. If you smell gas

• shut off gas supply

• do not try to light any appliance

• do not touch any electrical switch; do not use

any phone in your building

• immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions

• if you cannot reach your gas supplier, call

the fire department

5. This heater shall not be installed in a bedroom

or bathroom unless installed as a vented appli-

ance (see Installing Damper Clamp Accessory

for Vented Operation, page 11).

6. Before installing in a solid fuel burning

fireplace, the chimney flue and firebox must

be cleaned of soot, creosote, ashes and loose

paint by a qualified chimney cleaner. Creosote

will ignite if highly heated. A dirty chimney

flue may create and distribute soot within

the house. Inspect chimney flue for damage.

If damaged, repair flue and firebox before

operating heater.

7. Do not burn solid-fuel in a masonry or UL127

factory-built fireplace in which a vent-free

room heater is installed.

8. If fireplace has glass doors, never operate this

heater with glass doors closed. If you operate

heater with doors closed, heat buildup inside

fireplace will cause glass to burst. Make sure

there are no obstructions across openings of

fireplace.

9. This log heater is designed to be smokeless. If

logs ever appear to smoke, turn off heater and

call a qualified service person. Note: During

initial operation, slight smoking could occur

due to log curing and heater burning manu-

facturing residues.

10. To prevent the creation of soot, follow the instruc-

tions in Cleaning and Maintenance, page 20.

11. Before using furniture polish, wax, carpet

cleaner, or similar products, turn heater off.

If heated, the vapors from these products may

create a white powder residue within burner

box or on adjacent walls or furniture.

12. This heater needs fresh, outside air ventilation to

run properly. This heater has an oxygen depletion

sensing (ODS) pilot light safety system. The

ODS shuts down the heater if not enough fresh

air is available. See Air for Combustion and

Ventilation, page 5. If heater keeps shutting off,

see Troubleshooting, page 22.

13. Do not run heater

• where flammable liquids or vapors are used

or stored

• under dusty conditions

14. Do not use this heater to cook food or burn

paper or other objects.

15. Do not use heater if any part has been exposed

to or under water. Immediately call a qualified

service technician to inspect the room heater

and to replace any part of the control system and

any gas control which has been under water.

16. Do not operate heater if any log is broken. Do

not operate heater if a log is chipped (dime-

sized or larger).

17. Turn heater off and let cool before servicing, install-

ing, or repairing. Make sure the selector switch is in

the OFF position. Only a qualified service person

should install, service, or repair heater.

18. Make sure the selector switch is in the OFF

position when you are away from home for

long periods of time.

19. This heater must not be connected to any

external electrical source.

20. Operating heater above elevations of 4,500

feet could cause pilot outage.

21. Provide adequate clearances around air

openings.

PRODUCT IDENTIFICATION

Figure 1 - Product Identification

Control
Knob

Piezo
Ignitor

Log Set

Base
Assembly

Optional
Remote
Control

Flame
Adjustment
Knob

Optional
Selector
Switch

Advertising