Delta Tau MACRO CPU BOARD 4Ax-602804-xHxx User Manual
Macro cpu board
Advertising
Table of contents
Document Outline
- INTRODUCTION
- 3U MACRO-CPU CONFIGURATION
- 3U MACRO CPU BOARD HARDWARE SETUP
- 3U MACRO-CPU JUMPER AND SWITCH CONFIGURATIONS
- 3U MACRO-CPU Card Layout
- E1: Watchdog Timer Disable
- E2: CPU Mode Operation
- E3: Serial Port Baud Rate
- E4: Power Supply-Loss Control \(±15Vdc Supply
- E5: MACRO Received Signal Detect/Bypass Mode (rev -105 and 106 only). Does not exist on rev 107 and later models.
- E40: MACRO Input (Fiber/Wired) Selector
- JP3: MACRO Loop back Test Select For Copper Only (rev -104 and earlier)
- JP4: Reserved for Future Use
- JP5-JP6: MACRO Copper EQ Select (rev -104 and earlier)
- Switch Configurations
- Connector Summary
- 3U MACRO-CPU Card Layout
- MACRO STATION CHARACTER DISPLAY
- HARDWARE RE-INITIALIZATION
- FIRMWARE UPDATES
- 3U MACRO-CPU BOARD CONNECTOR PIN-OUTS
- U MACRO-CPU HARDWARE MEMORY MAP
- ACCESSORIES