ESI UGM96 User Manual

Page 13

Advertising
background image

UGM96

ESI

13

As with inputs, your output busses can also be mono or stereo. The example above shows one
stereo output bus which will be the typical setup when using UGM96. Under Device Port you can
assign the physical hardware output channel to each channel of each bus. The two stereo headphone
outputs of UGM96 will both send out the same signal from Cubase LE 4 as assigned in this dialog.

You can now start using Cubase LE 4 by opening an existing project or creating a new project. The
input and output busses you have created can be assigned to the individual tracks of your project.

5.5 Installation of Studio Devil Virtual Guitar Amp

UGM96 ships with the Studio Devil Virtual Guitar Amp from Gallo Engineering. If you are not
using this virtual guitar amplifier plugin, you can skip this section, however we strongly
recommend it. Studio Devil VGA is provided as VST, Audio Unit and RTAS plugin that can be
used (not only) in Cubase LE 4.

Installation

To install the Studio Devil VGA, insert the Installation CD into the DVD-ROM drive of your
computer. Under Windows, please launch the installer setup.exe from the folder
Softwarebundle\Studio Devil\Virtual Guitar Amp\PC. To install it under Mac OS X, open the Studio
Devil VGA disk image file from the Softwarebundle\Studio Devil\Virtual Guitar Amp\Mac folder
and then double click on the installer package.

To proceed with the installation, follow all instructions on screen. Please also check the content of
the readme.txt files in each folder.

Initial Setup

In most cases the installation folders will be automatically recognized by each plugin host
application. In some cases, you will need to add the appropriate folder to your host application’s list
of plugin folders. Consult the documentation of your host application for instructions on how to do
this, if necessary. You can find more information about usage with Cubase LE 4 in section 6.2 of
this manual.

Activation

Before you can use Studio Devil VGA, you need to activate it by getting a LICENSE KEY. You are
entitled to install and activate this software as many times as needed, but you are limited to using it
on one machine at a time. If you plan on using this software on multiple machines at the same time,
you might need to purchase additional serial numbers. Please check the Studio Devil website for
more information.

When you load Studio Devil VGA inside a host software (see sections 6.2 and 6.3 for more
information), it will run in DEMO MODE and you will see the screen on the left below. Click
Activate and the dialog on the right will appear:

Advertising
This manual is related to the following products: