ETA Calderon - Manual (Page 28)

– Use the pot only with the power cord that makes up its part! If the power cord is
damaged, never replace it with a power cord that is not of the same type.
– The appliance is portable and it is equipped with a movable connector with a plug, which
ensures double-pole disconnection from power supply.
– The power cord must not be damaged with sharp or hot objects, open fire and it must not
be sunk into water.
– Never put the power cord on hot surfaces or do not let it hang over the edge of a table
or a work top. Plugging or pulling the power cord e.g. by children can result in tilting over
or drawing the appliance down and serious injury!
– Check the condition of the power cord of the appliance regularly.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Use the appliance only with original accessories from the producer.
– Use the appliance only for the purpose it is intended for as specified in this manual.
Never use the appliance for any other purpose.
– The manufacturer is not responsible for damage caused by improper use of the
appliance and the accessories (e.g. food deterioration, injury, burning, scalding, fire)
and its guarantee for the appliance does not apply in situations when the safety warnings
above are not complied with.
II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (Fig. 1)
A – steam pot
A1 – water container A6 – filling hole
A2 – time switch A7 – heating element cover
A3 – control light A8 – drip tray
A4 – water gauge A9 – lid
A5 – carry handles
B – cooking bowl (3 pieces)
C – rice/soup tray
D – lid
D1 – handle
III. PREPARATION AND USE
Remove all the packing material, take out the steam pot and all the accessories. Place the
pot on flat and dry surface (e. g. kitchen table) in the height of at least 85 cm, out of reach
of children. (see par. I. SAFETY WARNINGS). Before the first use, wash the parts that
will be in contact with food in hot water with a detergent, rinse thoroughly with clean water,
wipe till dry or let it dry. Fill in the container with about 0.5 L clean water and assemble
all parts of the steam pot. Set the timer to 10 minutes while steam is created. After lapse
of the time, let the pot cool down and then pour the remaining water from the pot. Now the
appliance is ready for use. Possible short-time mild smoke when the appliance is operated
for the first time is not a defect and the appliance is not subject to a complaint for this
reason.
1) Time switch A2: enables setting the preparation time of the maximum length of 30
minutes. After lapse of the set time, the sound signal will go off and
heating will stop.
2) Control light A3: signals operation of the appliance.
28
GB
/ 60