Fat Bagger CHIN SPOILER User Manual
Page 2
Advertising
2. Take off nuts and washers to remove rthe backing strap Then position the chin spoiler in place
with voltage regulator protruding through the hole in its face. You’ll need to move some lines or
cables around to get it to sit into place. Line up the steel backing strap and loosely put on washers
and locking nuts.
3. Now tighten the lock nuts into place. Be careful not to over-tighten so you don’t crack the fiberglass.
www.fatbaggers.com
(641)774-7499
1. Begin your installation by removing the reflectors on the down tubes, they are easily pulled off.
Then use some carburetor cleaner or other solvent or adhesive remover to remove the sticky resi-
Advertising