Fat Bagger 500 REMOVABLE TOURPAK MOUNT - Manual

INSTALLATION INSTRUCTIONS
FBI REMOVABLE TRUNK MOUNT FBI500, FBI500-09 for H-D
®
Tour-Pak™
NOTE: This mounting unit has no allowance for mounting of license plate frame, remote mount amplifier or other
items mounted on underside of OE mount. Customer is responsible for relocation of such items on bike.
1. The FBI Removable Trunk mount is available for two year-range fitments. FBI500 fits 1996-2008 H-D
Touring Models while FBI500-09 fits 2009 and later.
a. FBI500 for 1996-2008 mounts on your existing backrest mounting hardware for the rear
attachment points but new stainless steel spool/bushings are provided to replace front mounting
points—the vast majority of these touring models came with the backrest hardware on them. If
your bike does not have them, call FBI for a hardware kit sold separately.
b. FBI500-09 for 2009-Up includes mounting hardware necessary for mounting this unit on your
bike. Actually you will still use the spacer behind each rear shock top mount for the front
mounting points and new Stainless Steel posts/bolts provided with this kit for the rear points--
replace and install them into the bolt holes that secure the saddlebag support rails into the
fender strut.
2. Remove Existing Tour Pak from your motorcycle and lay it on its top on a padded bench.
3. Remove the bolts which attach the Tour Pak to its original H-D mounting bracket and set that bracket
aside—it will not be re-used.
4. To determine where you want to position the trunk atop this new mount, it is best to put the mount on
your bike, set the trunk on it and decide where you want it to be in a front-to-back location to provide
optimal comfort for the passenger. Use a marker to mark through the holes in the mount to indicate
where to drill holes for the ¼”x1” bolts included which you’ll use to attach the trunk to the new mount.
NOTE: You will most likely need to drill 4 holes in the bottom of the trunk since there are variations in the
placement of the original holes and because you may want it further forward or back than the original
holes would locate it.
5. Put the trunk back on your padded bench then drill the holes you just marked in for the ¼”x1” bolts
included with this kit.
6. Now place the FBI Mount on the bottom side of the Trunk and bolt it into place.
7. Install your Tour Pak with the new mount onto your bike.
138 East Lincoln Ave. | Chariton, Iowa 50049 | (641) 774-7499 | fax: (641) 774-7505 | www.fatbaggers.com