Fat Bagger 500 REMOVABLE TOURPAK MOUNT - Manual (Page 5)

138 East Lincoln Ave. | Chariton, Iowa 50049 | (641) 774-7499 | fax: (641) 774-7505 | www.fatbaggers.com
INSTALLATION INSTRUCTIONS
FBI500-09-FIX REMOVEABLE TRUNK MOUNT
For use with 2009-UP H-D® KING Tour-Paks™
NOTE: This mounting unit has no allowance for mounting of license plate frame, remote mount amplifier or other items
mounted on underside of OE mount. Customer is responsible for relocation of such items on bike.
REMOVING THE SADDLEBAGS & ORIGINAL TOUR-PAK FROM YOUR BIKE:
1. Begin by removing your saddlebags and set them well away from your work area. Now remove your
complete Tour Pak and its mounting assembly from your motorcycle. This process will vary depending
on if you have the bolted mount or the H-D removable mount assembly or other aftermarket units. Once
removed, lay it on its top on a padded bench and remove the bolts which attach the Tour Pak itself to the
mounting apparatus. If you initially just removed the Tour Pak from the mounting apparatus, then now
remove the apparatus as well.
2. Now, if your bike has them, remove the H-D 2-point or 4-Point Mounting hardware that bolt into the
fender struts from your bike as well. These components will not be reused with this installation. See
images #1-3 of images with the 2-point, 4-point and no hardware for reference.
3. We will first install the new FBI mount on your bike, and then mount the Tour Pak on top of it later.
INSTALLING THE NEW FBI TRUNK MOUNT ON YOUR BIKE:
4. HARDWARE KIT INCLUDES: See Image #5
a. (2) stepped bushings
b. (2) thick washers with recessed back side and small hole
c. (2) ¼” X 1-1/4” Bolts
d. (2) thick washers with recessed back side and large hole
e. (2) large narrow washers
f. (4) ¼”X1” Hex Head Bolts with (4) nuts and (8) washers
5. Items a, b, and c above are used for the rear attachment points and items d and e are used for the front
attachment points.
6. REAR ATTACHMENT POINTS—the rear attachment point of the FBI mount utilizes existing bolt holes
in the fender struts. There is a chrome rail that comes up from the bottom saddlebag support framing
and bolts into the fender strut on each side of the bike. See IMAGES #7 & #8. Remove these 2 bolts to
prepare for installation of new hardware. The 2 stock bolts will not be reused.
a. See IMAGE #6. Take one of the c. bolts in the hardware kit and slip it through washer/spacer item b.
above with the recessed side of the spacer facing away from the bolt head.
Page 2—FBI500-09-FIX Removable Trunk Mount