Fat Bagger 500 REMOVABLE TOURPAK MOUNT User Manual
Page 4
Page 2
8. Holding these four spacers in place on the FBI mount, lower the mounting unit into place over the bike and
align the holes of the mount with the front and rear backrest mounting holes. Insert the (2) short chrome
bolts with washers in the front mounting holes (you’ll see that these front spacers mate up to the shock
spacers installed earlier) and the (2) long chrome bolts with washers in the rear mounting holes. Thread all
(4) bolts in, make sure that all spacers are in place and set through the fender against the fender strut, then
tighten these (4) bolts and the (2) shock bolts.
INSTALLING YOUR TOUR PAK ON THE NEW FBI MOUNT:
9. With the Tour Pak upside down on its top on a padded bench, remove the bolts which attach the Tour Pak to
its original H-D mounting bracket, remove the mount and set it aside—it will not be re-used.
10. To determine where you want to position the trunk atop the new FBI mount, set the trunk on it and decide
where you want it to be in a front-to-back location to provide optimal comfort for the passenger.
11. Use a marker to mark up through the holes in the mount to indicate where to drill holes for (4) ¼”x1” bolts,
included, which you’ll use to attach the trunk to the new mount. NOTE: You will most likely need to drill 4
holes in the bottom of the trunk since there are variations in the placement of the original holes and because
you may want it further forward or back than the original holes would locate it.
12. Put the trunk back on your padded bench then drill the holes you just marked in for the ¼”x1” bolts included
with this kit.
13. Now set the Tour Pak back on top of the mount, on your bike, and bolt it into place using the ¼”x1” bolts and
flat washers provided.
14. Your installation is now complete.
138 East Lincoln Ave. | Chariton, Iowa 50049 | (641) 774-7499 | fax: (641) 774-7505 | www.fatbaggers.com
IMAGE #1 HARDWARE KIT: Left to right,
(2) Round spacers with notch, (2) Short
Stepped spacers, (2) Long Stepped
Spacers.
IMAGE #2 FBI Fixed Trunk Mount
IMAGE #3 FBI Fixed Trunk Mount mounted in
place on a bike.