FiberPlex VIM-1032 - Manual (Page 9)

7
Getting Started
Setting up, and using your Light Viper 1832 is a quick and simple process. Just follow these steps:
1. Place the Stage Box in a location central to the majority of your signal sources. Place the Mixer Box close enough to the mixer so
that the send cables can reach the console’s inputs, connect AC power
2. Connect and run the Fiber between the two boxes, power up and check the Sync light on both units
3. Connect the inputs and returns to the stage box. (Be sure to select the appropriate Gain and Phantom Power settings)
4. Connect the fan out cables to the console (send & return on VIS‐1832, send only on VIS‐1032)
5. Turn on phantom power as necessary.
6. Starting with a gain setting of 0 dB, set the gain switch at the highest gain setting which the clip light either just flashes at the peaks
or is off.
7. Start mixing.
NOTE: the signal coming into the console will be line level. When the gain switches on the VIS‐1832 are properly set, the signal going into the
console will be hot. Use line level inputs or engage input pads to achieve optimal signal‐to‐noise ratio.
The more advanced functions of the Light Viper 1832 (control, clocks, etc.) are addressed later in this manual.