Fire Magic 3593 New Ice Maker - Manual (Page 12)

REV 1 - 1401311400 L-C2-393 12
INSTALLATION (cont.)
To Remove Door From Hinges
1. Remove the top hinge cover.
2. Using a Phillips screwdriver, remove the screws, then remove top hinge mat and top hinge. Keep
the parts together and set them aside.
3. Lift the door off of the bottom hinge and turn it upside down so that the handle is on the right. Set
the door aside.
To Replace Door From Hinges
1. Using a fl at screwdriver, remove the plug buttons from the screw holes opposite the door hinges,
top and bottom. Set aside.
2. Remove the bottom hinge and place it on the opposite side at the bottom of the door.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and replace the top hinge and top hinge mat.
5. Replace top hinge cover.
6. Push the plug buttons into the original screw holes.
WATER SUPPLY
The water supply should be ready at the point of installation. The water supply pressure should be a
minimum of 15 psig with a static pressure not more than 80 psig. (A wall outlet directly behind the ice
machine will make installation easier.)
IMPORTANT:
• All installations must be in accordance with local plumbing code requirements. Professional
installation is recommended.
• Make certain that the hoses are not pinched or kinked or damaged during installation.
• Check for leaks after connection.
Tools required: 1 / 2 " open-end wrenches, Phillips screwdriver
Rear of unit
Water inlet
Drain outlet