Fire Magic 3593 New Ice Maker - Manual (Page 27)

REV 1 - 1401311400 L-C2-393 27
TROUBLESHOOTING (cont.)
PROBLEM POSSIBLE CAUSE CORRECTION
Cubes are
partially formed
or are white at
the bottom
1. Not enough water in the water trough 1. Check if the water supply pressure is below
15 psig.
Check water supply; fi lter may be restricted.
Check for a water leak at the water trough.
Noise during
operation
1. The legs are not leveled and locked
2. Certain sounds are normal
1. Level and lock the feet. See LEVELING
THE ICE MAKER.
2. See NORMAL SOUNDS.
The ice maker
stops suddenly
while making
ice
1. The electricity is off
2. The room temperature is out of the
stated range
3. The ice storage bin is full of ice
1. Reconnect the power supply line.
2. Cut off the electricity; let the ice maker stop
working until the temperature returns to
within the stated range.
3. Remove some ice; be sure ice-full probe
is free of ice.
The body of the
ice maker is
electrifi ed
1. The ground line isn't in the socket 1. Use a socket meeting the required electrical
standard.
Scaling occurs
frequently inside
the machine
1. The water is too hard 1. Using a water-softening device installed in
front of the water inlet
Water leaks from
the ice storage
bin
1. The drain hole below the ice storage
bin is blocked
2. The drain hose is kinked or improperly
placed higher than the fl oor of the ice
storage bin
1. Pull out the ice storage bin and clean the
drain hole.
2. Check the drain hose to make sure the
water can drain out unhindered.