Flowserve MJ Slurry - Manual (Page 8)

MJ SLURRY USER INSTRUCTIONS ENGLISH 71569294 - 02/08
Page 8 of 54
®
occur if there is heat input to the liquid. This can occur
if the pump is stationary or running.
Bursting of liquid containing parts due to freezing must
be avoided by draining or protecting the pump and
ancillary systems.
Where there is the potential hazard of a loss of a seal
barrier fluid or external flush, the fluid must be
monitored.
If leakage of liquid to atmosphere can result in a
hazard, the installation of a liquid detection device is
recommended.
1.6.4.7 Maintenance to avoid the hazard
CORRECT MAINTENANCE IS REQUIRED TO
AVOID POTENTIAL HAZARDS WHICH GIVE A RISK
OF EXPLOSION
The responsibility for compliance with maintenance
instructions is with the plant operator.
To avoid potential explosion hazards during
maintenance, the tools, cleaning and painting materials
used must not give rise to sparking or adversely affect
the ambient conditions. Where there is a risk from
such tools or materials, maintenance must be
conducted in a safe area.
It is recommended that a maintenance plan and
schedule is adopted. (See section 6, Maintenance.)
1.7 Nameplate and warning labels
1.7.1 Nameplate
For details of nameplate, see the Declaration of Conformity.
1.7.2 Warning labels
WARNING
MECHANICAL SEAL FITTED
DO NOT ADJUST PUMP CLEARANCE WITHOUT
REFERENCE TO MANUFACTURER’S INSTRUCTION
MANUAL
WARNING
BEFORE STARTING THE PUMP ON SERVICE, CHECK
TO ENSURE CORRECT ROTATION OF MOTOR.
FAILURE TO DO THIS COULD RESULT IN SERIOUS
DAMAGE TO THE EQUIPMENT.
MECHANICAL SEAL WARNING ROTATION WARNING
P/N 2113931-001 P/N 2113932-001
WARNING
BEFORE GROUTING, REALIGN THIS UNIT
RECHECK ALIGNMENT BEFORE STARING,
FAILURE TO DO THIS COULD RESULT IN
SERIOUS DAMAGE TO THE EQUIPMENT.
REFER TO INSTALLATION MANUAL AND, OR
COUPLING INSTRUCTIONS FOR METHOD OF
CHECKING ALIGNMENT.
WARNING
THESE EYEBOLTS
ARE TO BE USED FOR LIFTING BEARING
CARTRIDGE AND SHAFT ONLY.
DO NOT USE FOR LIFTING ENTIRE UNIT.
GROUT WARNING LIFTING WARNING
P/N 2113934-001 P/N 9901701-001