Flowserve 3400IQ Digital Positioner - Manual (Page 4)

Logix 3400IQ Digital Positioner FCD LGENIM3401-00 – 06/06
4
1 Terms Concerning Safety
The safety terms DANGER, WARNING, CAUTION and NOTE are used in these instructions to
highlight particular dangers and/or to provide additional information on aspects that may not be
readily apparent.
b DANGER: Indicates that death, severe personal injury and/or substantial property damage
will occur if proper precautions are not taken.
c WARNING: Indicates that death, severe personal injury and/or substantial property
damage can occur if proper precautions are not taken.
a CAUTION: Indicates that minor personal injury and/or property damage can occur if proper
precautions are not taken.
NOTE: indicates and provides additional technical information, which may not be very obvious even
to qualified personnel. Compliance with other, not particularly emphasized notes, with regard to
transport, assembly, operation and maintenance and with regard to technical documentation (e.g.,
in the operating instruction, product documentation or on the product itself) is essential, in order to
avoid faults, which in themselves might directly or indirectly cause severe personal injury or property
damage.
2 General Information
The following instructions are designed to assist in unpacking, installing and performing mainte-
nance as required on Flowserve Valtek Logix
® 3400IQ digital positioners. Series 3000 is the term
used for all the positioners herein; however, specific numbers indicate features specific to model
(i.e., Logix 3400 indicates that the positioner has F
oundation
Fieldbus protocol). See Logix 3400IQ
Model Number table in this manual for a breakdown of specific model numbers. Product users
and maintenance personnel should thoroughly review this bulletin prior to installing, operating, or
performing any maintenance on the valve.
Separate Valtek Flow Control Products Installation, Operation, Maintenance instructions cover the
valve (such as IOM 1 or IOM 27) and actuator (such as IOM 2 or IOM 31) portions of the system and
other accessories. Refer to the appropriate instructions when this information is needed.
To avoid possible injury to personnel or damage to valve parts, WARNING and CAUTION notes must
be strictly followed. Modifying this product, substituting non-factory parts or using maintenance
procedures other than outlined could drastically affect performance and be hazardous to personnel
and equipment, and may void existing warranties.
c WARNING: Standard industry safety practices must be adhered to when working on this
or any process control product. Specifically, personal protective and lifting devices must be
used as warranted.