Flowserve ORGS 11-2 - Manual (Page 13)

13
The measuring range can be switch-selected between
≥
0.5 µS/cm and
≥
10 µS/cm
by means of a code switch :
1. Undo screws of the electrode terminal and remove housing cover , fig. 3.
Code switch 1 - 4 OFF Measuring range
≥
0.5 µS/cm
Code switch 1 - 4 ON Measuring range
≥
10 µS/cm
2. Mount housing cover and fasten screws .
Standard Setting
Factory setting
The equipment features the following factory set default value:
■ Measuring range
≥
10 µS/cm
Switch selection of measuring range
Attention
■ Screwdriver for cross head screws, size 1
■ Screwdriver for slotted screws, size 2.5; completely insulated according to
VDE 0680
■ Make sure not to damage the electronic components when setting
the code switch.
■ Do not use a pencil to set the code switch!
Tools
H
J H
J
5