Fluke Biomedical ASM-990 Series - Manual (Page 12)

ASM-990 Series
Operators Manual
2-4
Figure 2-5. Main Menu Display
Modes Sub-Menu
To select a different mode, use the “UP” arrow key to highlight “MODES;” then press the “SEL” key. The
screen will now appear as in Figure 2-6.
MAIN MENU
SWITCH TO INTG
MODES
SETUP
DATA REVIEW
IrDA COMMUNICATION
MODES SUB-MENU
RATE
INTEGRATE
SCALER
PEAK HOLD
LOG DATA
Figure 2-6. Modes Sub-Menu
Rate Sub-Menu
If the user selects “RATE” from “MODES SUB-MENU”, the operating mode is then set to the “RATE”
mode; the “RATE UNIT SUB-MENU” will appear on the screen (see Figure 2-7). The currently selected
unit will be highlighted. The “CAL DUE” date, corresponding to the highlighted units, will also appear at
the bottom of the screen. The selection of different units can then be done by first pressing the “UP” or
“DOWN” arrow keys (to highlight the desired selection), then pressing the “SEL” key. If the user desires
not to select a different unit, he can press the “ESC” key. (Note: the items displayed on the sub-menu
depend on the probe/calibration data.)
RATE UNIT SUB-MENU
cps
cpm
mR/hr
mrem
uSv/hr
Bq/cm² Tc-99m
Bq/100cm² Tc-99m
Bq/cm² Cs-137
Bq/100cm² Cs-137
Bq/cm² Co-57
CAL DUE: 09/06/03