Fluke Biomedical ASM-990 Series - Manual (Page 23)

Operation
Message Display
2
2-15
2.5 Messages Display
Messages such as “LOW BATTERY,” “OVERRANGE,” and the location of the next survey (if enabled) are
one line in length and will be displayed near the lower edge of the LCD.
The message “HV FAULTS” is one line in length and will be displayed near the lower-center portion of the
LCD. (Note: it will be necessary to cycle power to remove the “HV FAULT.” In order to avoid this fault
altogether, the user should always connect the desired probe BEFORE turning the unit “on.”)
Jam Condition
If a “JAM” condition occurs the screen will appear as shown below in Figure 2-33.
Figure 2-33. JAM
Mode
2.6 Probe Selection
If the user has more than one probe (i.e. there is more than one set of calibration data stored in EEPROM
memory), the first screen displayed will be the “PROBE INFO” screen (see Figure 2-34) after the
“VICTOREEN” logo disappears. This allows the user to ensure that the correct probe has been selected
for that particular measurement. Highlighting “NO,” then pressing “SEL,” will then display a list of
additional probes that can be selected (see Figure 2-35).
PROBE INFO
MODEL #:
489-50
SERIAL #: 002132
CAL DATE: 09/06/02
CAL CYCLE: 12 MOS.
CAL DUE:
09/06/03
IS PROBE CORRECT?
NO
YES
PROBE SELECTION
PROBE #1
PROBE #2
PROBE #3
“
“
PROBE #N
NOT LISTED
Figure 2-34. Probe Selection Figure 2-35. Probe Selection