Formax FD 260-10 - Manual (Page 13)

9
NOTE
The detachable POWER CORD may have to be
changed to match the particular power-source
output.
1. Unplug the POWER CORD.
2. Use a small screwdriver or similar tool to push up
on and release the FUSE DRAWER LOCKING
TAB.
3. Pull the FUSE DRAWER out of the POWER
ENTRY CASING.
4. Pull the VOLTAGE SELECTOR out of the
POWER ENTRY CASING.
5. Rotate the VOLTAGE SELECTOR until the correct
voltage is on the same side as the VOLTAGE
SELECTOR WINDOW.
6. Place the VOLTAGE SELECTOR in the POWER
ENTRY CASING and verify the correct voltage
selection.
7. Place the FUSE DRAWER in the POWER ENTRY
CASING.
POWER ENTRY
FUSE
FUSE DRAWER
APPLIANCE INLET
LOCKING TAB
CASING
VOLTAGE
SELECTOR
WINDOW
FUSE DRAWER
POWER CORD
VOLTAGE
SELECTOR
Figure 3.1 -- FD 260-10 Power Connection