Formax FD 260-10 - Manual (Page 20)

16
5. OPERATION
5.1 Loading
Mail Pieces
FEED TRAY
PRODUCT GUIDE
PRODUCT GUIDE
SEPARATOR KNOBS
SEPARATORS
FEED ROLLS
PRODUCT STOP
PRODUCT WEDGE
PRODUCT WEDGE
POWER SWITCH SPEED KNOB
KNOB
KNOBS
PRODUCT GUIDE
Figure 5.1 -- Operating the FD 260-10
1. Center the mail pieces with the FEED ROLLS
(refer to Figure 5.1).
2. Loosen the PAPER GUIDE KNOBS and slide the
PAPER GUIDES against a sample stack of mail
pieces. Tighten the knobs, making sure the mail
pieces remain flat in the FEED TRAY and can
slide toward the FEED ROLLS. If not, repeat this
step until they do. Remove the stack.
3. Place one mail piece in the gap between the
SEPARATORS and the FEED ROLLS.
4. Loosen the SEPARATOR KNOBS, then lift each
one up and drop the SEPARATORS onto the mail
piece.