Formax FD 260 - Manual (Page 30)

26
7.2 Replacing a
Fuse
7.2.1 Line Fuse
When one or both LINE FUSES are blown, the FD
260 will appear to have no power and the LINE FUSE
must be replaced.
WARNING
UNPLUG THE POWER CORD BEFORE OPENING
THE FUSE DRAWER.
To replace a LINE FUSE:
1. Use a small screwdriver or similar tool to push up
on the FUSE DRAWER LOCKING TAB to release
this locking tab. (Refer to Figure 7.1.)
2. Pull the FUSE DRAWER out of the POWER
ENTRY CASING. (Refer to Figure 7.1.)
Figure 7.1 – Replacing a Line Fuse