Install os by using e-sata – Foxconn N68S7AA-8EKRS2H User Manual
Page 83
Appendix
75
Install OS by using e-SATA
1. BIOS Setup
Before installing Operating System by using e-SATA device,you need to set the
BIOS setup first.
Step 1. Make sure the ‘Onboard e-SATA Device’in the ‘Advanced BIOS
Features’section is enabled.
Step 2. Select the e-SATA Mode.
If you select [IDE] in “e-SATA Mode Select” then no other special steps required for
installing OS.
If you select [AHCI] in “e-SATA Mode Select” ,please follow the below instructions
in ”2.Installing setup(AHCI Mode)”
Step 3. Save and exit the BIOS setup,correct connecting the e-SATA device before
reboot you PC.
2. Installing Setup(AHCI Mode)
Step 1. Create e-SATA Driver Floppy.
Please refer to the’’Bootable RAID Array”in
page 62.
Note:
AHCI Mode support SATAII NCQ,better performance.
PDF 文件使用 "pdfFactory" 试用版本创建