Dish Network Solo 351 - Manual (Page 31)

Chapter 2
Page 26
Receiver Description and Installation
Removing the Recover Button Channel Programming
The following instructions describe how to reset the RECOVER button to
the way it was delivered to you from the factory.
1. Press and hold the TV mode button until all the other mode
buttons light up, and then let go of the button. The TV mode
button flashes.
2. Press the STAR (*) button.
3. Press 0-0-0.
4. Press the POUND (#) button. The TV mode button flashes three
times.
Changing the TV1 and TV2 Output Channels
The receiver comes preset to use channel 3 for TV1 and off-air channel 60
for TV2 . If you are experiencing interference on the channels you are using,
follow these instructions to change the channel that TV1 or TV2 uses.
1. Press MENU-6-1-5 to open the Modulator Setup screen.
2. For TV1 Out , highlight the number under TV1 Out . For TV2 Out skip to
step 4.
3. Use the UP and DOWN ARROW buttons to change the modulator
channel either 3 or 4 . Continue to the next step to set TV2 Out or skip to
step 7 if you are finished making changes.
Make sure you are familiar with how to change channels on
your TV and if necessary how to switch your TV between off-
air and cable channels. When you change these receiver output
channels, you must also change the channels on your TV(s) to
tune to these channels to see the video from the receiver. See
your TV user guide for instructions.
Tip: It’s easier to
set the output
channel from the
opposite TV. For
example, if you are
changing the out-
put on TV1 (nearby
TV), use TV2
(remote TV) to
make the change.
When you save the
changes, simply
remember to
change the chan-
nel on the nearby
TV.