GAI-Tronics F95090E 12 V DC @ 8.3 A Rack-Mount Power Supply - Manual (Page 2)

Pub. 42004-282
Model F95090E 12 V dc @ 8.3 A Rack-Mount Power Supply Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-282.doc
3/98
Figure 2. Power Supply—Rear Terminations
Installation
WARNING
Disconnect ac power during wiring. This device can present a shock hazard. Please use care when
handling this device and be sure that the ac power is not connected during wiring.
Wiring
Depth clearance behind the mounting rails should be at least twelve to fourteen inches for wiring.
1. Run power cord to the ac power outlet which will power this unit, but do not connect power until the
entire installation is complete.
2. Run the dc power conductors from the devices requiring 12 V dc power, to the output terminals as
shown in Figure 2.
Specifications
Input power .................................................... Nominal: 120 V ac; Range: 85-264, 50/60 Hz, single phase
Output power.................................................................................................... 12 V dc @ 8.3A maximum
Output type ...............................................................................................................Switched @ 120 kHz
Efficiency ....................................................................................................76% typical @ maximum load
Controls................................................................................................ On/off toggle switch on front panel
Indicators ................................................................. Red LED on front panel (illuminates when operating)
Material/Finish ..............................................16 gauge cold rolled steel with gray polyurethane paint finish
Mounting.................................................................... Standard 3U (5.25 inch) 19-inch EIA rack mounting
Connections .................................................................................................... Barrier-type terminal blocks
Dimensions...............................................................5.25 (133) H
× 19 (483) W × 6 (152) D; inches (mm)
Temperature range................................................................................0º C to +49º C (+32º F to +120º F)
Humidity ......................................................................................................... 0% to 85% non-condensing
Weight......................................................................................................... Approximately 5 lbs (2.26 kg)