GAI-Tronics 751-005 Speaker Amplifier (ATEX Zone 2/CE Mark) - Manual

Pub. 42004-366C
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374  800-492-1212  Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Model 751-005
Speaker Amplifier
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 751-005 Speaker Amplifier is a component of the 700 Series Page/Party ® System. It mates
directly with the Page/Party ® series enclosures and broadcasts page announcements over the Page/Party ®
system speakers. The Model 751-005 is constructed of 16-gauge cold-rolled steel and is suitable for
either indoor or outdoor use.
Installation
CAUTION
Do not install this equipment in hazardous areas other than those on the
equipment approval list in the “Specifications” section. Such installation may cause a safety hazard
and consequent injury or property damage.
WARNING
Do not disconnect equipment while the circuit is energized.
For continued IP 66 protection, torque setting for securing the amplifier to the enclosure should be 10 to
12 in-lbs. or 1.13 to 1.36 n-m. To install, plug the Model 751-005 Speaker Amplifier into the appropriate
enclosure, and tighten the four screws in the corners of the front panel. Refer to Figure 1 for typical
installation details.