GAI-Tronics ICS Offshore Stations - Manual (Page 3)

Pub. 42004-743L2CQG
ICS Off-Shore Page/Party
®
Station Quick Installation Guide Page 3 of 3
f:\standard ioms - current release\42004-xxxxqg quick guides\42004-743l2cqg.doc
11/14
Figure 3. Typical installation wiring configuration
N OTE : Station input power can be through system cable or through a separate power source cable.
See Pub. 42004-743L2 for the possible beacon and RTU activation configurations.
Front Cover Reattachment (Upper Enclosure)
Connect any cable harnesses that were disconnected during mounting. Place the front cover inside the rear enclosure, being careful
not to pinch any cables. Attach the front cover with the four screws and washers provided. Torque the screws to 10–12 in-lbs
(1.13–1.36 n-m). On the lower enclosure, swing the door shut and utilize the attached captive screws to secure the door (10–12 in-lbs.
torque).
NRTL Listed for USA and Canada ......................................................................................... Class I, Groups A, B, C, and D, Division 2;
Class II, Groups F and G, Division 2;
Class III, Division 2 Hazardous Locations
Temperature code, T4A – USA
T3C – Canada