GAI-Tronics 12513-002 Enc. Mid/rear section Valox - Manual (Page 2)

Pub. 42003-025C
M ODEL 12513-002 V ALOX E NCLOSURE M ID /R EAR S ECTION R EPLACEMENT K IT Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-025c.doc
04/06
Removing the Mid/Rear Section
1. Loosen the four screws located in the corners of the inside mid-section of the enclosure.
2. Swing the mid-section away from the rear section to access the rear mount screws.
3. Loosen the bushing nut inside the enclosure at the bottom.
4. Remove the nut, and pull the modular telephone line cord out of the assembly. Put aside the old
bushing and bushing nut.
5. Loosen the four screws fastening the enclosure to the wall, and remove it.
Installing the New Mid/Rear Section
1. With the mid-section swung out of the way, align the rear section with the mounting holes in the wall,
and fasten it using the same screws/bolts that were used previously.
2. Insert the previously used bushing in the bottom of the new enclosure. Insert the modular telephone
line cord through the bushing and enclosure, and fasten them with the previously used bushing nut.
3. Swing the mid-section back against the rear section, and fasten it with the four screws provided.
4. Reconnect the modular telephone line cord to the printed circuit board of the front panel assembly.
5. Fasten the front panel assembly to the mid-section of the new enclosure.
6. Mate the bottom hinge of the door with the bottom hinge of the mid/rear section of the enclosure.
7. Align the loose upper hinge with the secure hinge on the enclosure, and fasten it.