GAI-Tronics 12560-002 Power Supply Replacement TS958 - Manual

Pub. 42003-072
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Power Supply Replacement Kit
Model 12560-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The kit is for use on Model TS958 Tone/Speech Generators. This kit includes the following components:
Qty Description
1 Fuse Rating Label
2 Screw
1
115 Power Supply PCBA
Installation
CAUTION
Before installing this kit, make sure all the power to Model TS958 is shut off. Failure to do so could
result in serious injury.
Removing the Old Power Supply
1. Loosen the 4 captive screws on the front cover of Model TS958.
2. Open the front cover. Locate the power supply on the right side of the rear panel. There is a shield
with a CAUTION HIGH VOLTAGE label on it covering the power supply.
3. Remove and discard the 2 screws in the upper left and lower right corners of the shield. Remove the
shield.
4. Unplug the connector from J1 on the power supply board.
5. Remove and save the 4 screws in the 4 corners of the power supply board.
6. Remove the power supply board.