GAI-Tronics 12761-002 Kit (9000 Series F/M and D/E Subsets) - Manual

Pub. 42003-074
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Handset Cradle/Sensor Assembly
Replacement Kit
Model 12761-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
This kit is for use on the following models: Model 9101, 9101A, 9105, 9105A, 9201, 9201A, 9205, and
9205A.
Installation
Models 9101, 9101A, 9105, and 9105A
Removing the Old Assembly
1. Remove the two mounting screws from the mounting bracket. Remove the subset from the mounting
bracket.
2. Remove the six screws holding the unit together.
3. Lay the unit open to access the PCBA.
4. Note the location of and remove the two reed switch wires from the PCBA.
5. Use a Phillips screwdriver to remove the two screws securing the handset cradle to the front panel.
Set the screws aside.
6. Pull the old cradle assembly through the front panel, and discard it.