GAI-Tronics 12566-001 Single Hub Kit - Manual

Pub. 42003-082
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Single Hub Replacement Kit
Model 12566-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
This kit is used on stations with cast aluminum enclosures. This kit includes the following components:
Qty Description
1 Single 1.25-inch Hub
1 Gasket, Flat Hub
1 Gasket, Tapered Hub
4 Screw
N OTE : Before installing this kit, disconnect the supply voltage to the station.
Installation
Removing the Old Hub
1. Loosen the four screws securing the handset or speaker amplifier assembly to the rear enclosure, and
unplug the station.
2. Note the location of the internal wiring as it will have to be reconnected after installing the new hub.
The wiring instructions can also be found in the original installation manual for the enclosure.
Disconnect the internal wiring. DO NOT allow the terminal ends to touch one another. Electrical
tape should be used to insulate the terminals from each other.
3. Remove the conduit from the hub to be replaced.
4. Remove and discard the four screws securing the hub to the enclosure.