GAI-Tronics 12251-001 Spring Kit - Manual

Pub. 42003-116A
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Modification Kit for GAI-Tronics
Non-Metallic Enclosure Door Spring
Model 12251-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
The Model 12251-001 Modification Kit is used on the following Page/Party
®
models and enclosures:
• 10444-003 • 660-102 • 659-101 • 730-104 • 730-106 • 7335-005
• 730-107 • 733-001 • 733-002 • 733-003 • 7335-001 • 7335-006
• 7335-002 • 7335-003 • 7305-104 • 7305-105 • 7305-107 • 7335-007
• 785-001 • 785-002 • 7855-001 • 7855-002 • 7335-004
This model is also used on the following stations:
• Model 476-001 Electro-Sound Station
• Model 473-002 Centra-Page Station
Installation
1. Units with stainless steel roll pin: Remove the lower
hinge by driving the pin out with a 5/32-inch pin punch.
Units with Telflon
® pin: Remove the lower hinge by
cutting the pin off below pin retainer using a knife or
chisel.
2. Ream the hole using a 0.187-inch diameter drill.
3. Refer to Figure 1. Position the spring as shown. Align the
coils of the spring with hinge hole while sliding new hinge
pin into the assembly.
4. Press new retainers into new hinge pin using a 3/16-inch
hex socket wrench. Leave a 1/16-inch clearance between
retainers and the spring.
Figure 1. Assembly Details