GAI-Tronics 12564-002 Party Line Knob Kit (EuroPage) - Manual

Pub. 42003-133A
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Party-Line Selector Knob Replacement Kit
M
ODEL
12564-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information which is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
This kit contains five of each of the knobs and caps.
Installation
1. Open the door to the enclosure.
2. Locate the party line selector knob. Pop the cap out of the center of the knob.
3. Remove the hex nut, washer, and party line selector knob. Note pointer position when removing and
ensure that the point is reinstalled in the same position.
4. Place the new knob over the party line selector switch.
5. Adjust the pointer position.
6. Tighten the hex nut against the washer in the selector switch knob.
7. Replace the cap in the center of the knob.