GAI-Tronics 12513-007 Mid-Rear Section - 351 - Manual (Page 2)

Pub. 42003-151
M ODEL 12513-007 V ALOX ® E NCLOSURE M ID - AND R EAR S ECTION R EPLACEMENT K IT Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-151.doc
11/95
Removing the Mid- and Rear Section
1. Loosen the four screws located in the corners of the inside mid-section of the enclosure.
2. Swing the mid-section away from the rear section to access the rear mount screws.
3. Disconnect the bushing and cable from the enclosure.
4. Loosen the four screws fastening the enclosure to the wall, and remove the enclosure from the wall.
Installing the New Mid- and Rear Section
1. With the mid-section swung out of the way, align the rear section with the mounting holes in the wall,
and fasten it using the same screw/bolts that were used previously.
2. Insert the previously used bushing in the bottom of the new enclosure. Insert the modular telephone
line cord through the bushing and the enclosure.
3. Swing the mid-section back against the rear section, and fasten it with the four screws provided.
4. Reconnect the modular telephone line cord to the printed circuit board of the front panel assembly.
5. Fasten the front panel assembly to the mid-section of the new enclosure.
6. Mate the bottom hinge of the door with the bottom hinge of the mid- and rear section of the enclosure.
7. Connect the upper hinge to the enclosure.