GAI-Tronics 12522-007 Piezo Speaker Replacement Kit for RED ALERT Emergency Telphones - Manual

Pub. 42003-241A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Piezo Speaker Replacement Kit
for RED ALERT™ Emergency Telephones
Model 12522-007
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12522-007 Piezo Speaker Replacement Kit is designed for use with GAI-Tronics’ RED
ALERT™ Series Emergency Telephones. It includes the following components:
Qty Description
1 Speaker assembly
1 Tie wrap
Installation
Removing Old Speaker Assembly
1. Use a Model 233-001 Security Screwdriver (Torx T-25 security tip) to remove the four screws (for
wall-mount) or six screws (for flush-mount) securing the front panel assembly to the enclosure. Save
the screws for reassembly.
2. Lift the front panel assembly approximately 6 to 8 inches away from the enclosure.
3. Unplug the telephone line cord from the modular block in the enclosure, or disconnect the telephone
line from TB1, depending on the installation.
4. Remove the front panel assembly and place it face down on a clean flat surface.
5. Use wire cutters to snip the tie wrap securing the push buttons(s) and speaker wires.