GAI-Tronics XCP0070A Direct Enhanced Phone Interface Kit User Manual
Page 5
Pub. 43003-018B
Model XCP0070A Direct Phone Interface Kit
Page: 5 of 5
11/02
7. Place the CTI PCBA on the standoffs and attach with the supplied #4-40 screws. The J13 connector
plugs into the P13 connector on the main control PCBA.
8. Attach the supplied ground cable to the ground screw located on the rear panel. Attach the other end
to the quick-disconnect on the CTI PCBA.
12. Reattach the ribbon cables (SLV-CBL-P) to their matching connectors.
13. Replace the rear cover and screws. Reattach all cables and reconnect the power.
Ring Detect Sensitivity
Jumper J400 is provided to allow operation under a wide range of ring voltages. It provides the following
two ring sensitivities:
JU400 IN (default) 70 V ac ring voltage
JU400 OUT (“parked”) 25 V ac ring voltage
Refer to the ICP9000 Series Desktop Console Operator’s Manual or the ICP9000 Navigator Series
Console Operator’s Manual for complete user instructions.