GAI-Tronics XCP0110A Replacement Button/Elastomer Kit - Manual (Page 3)

Pub. 43003-023A
Model XCP0110A Button/Elastomer Replacement Kit Page: 3 of 4
11/01
4. Place the front cover face down on a flat surface. Remove the ten #4-40 hex nuts and four #4-40
screws securing the PCBA. See Figure 2.
Note: Be especially careful not to dislodge the buttons from the front panel.
5. Gently remove the PCBA from the front cover.
6. Once free, you will see four separate elastomer actuators attached to the front side of the PCBA.
Remove either the damaged or all four elastomers based upon repair requirements. See Figure 3.
Figure 2. Inside of Front Cover
Figure 3. PCBA with Elastomer